-
Model List:
- Farmall 35A Tier 4B (Final) Tractor
- Farmall 40A Tier 4B (Final) Tractor
- 1. GENERAL INFORMATION
- 1.1. Note to the owner
- 1.2. Intended use
- 1.3. Electromagnetic Compatibility (EMC)
- 1.4. Product identification
- 1.5. Operators manual storage
- 1.6. Machine orientation
- 1.7. Emissions overview
- 2. SAFETY INFORMATION
- 2.1. Safety rules and signal word definitions
- 2.2. Safety rules
- 2.3. Do not operate tag
- 2.4. Roll Over Protective Structure (ROPS) frame Personal safety
- 2.5. Ecology and the environment
- 2.6. Safety signs
- 2.7. Instructional signs
- 2.8. Safety features
- 3. CONTROLS AND INSTRUMENTS
- 3.1. Access to operators platform
- 3.1.1. Access to operators platform
- 3.2. Operators seat
- 3.2.1. Seat belt
- 3.2.2. Mechanically adjusted operator seat
- 3.2.3. Roll Over Protective Structure (ROPS)
- 3.3. Forward controls
- 3.3.1. Instrument panel
- 3.3.2. Engine fault code display
- 3.3.3. Hydrostatic transmission Operate
- 3.3.4. Shuttle lever
- 3.3.5. Clutch pedal
- 3.3.6. Brake pedal
- 3.3.7. Foot throttle pedal
- 3.3.8. Hand throttle lever
- 3.3.9. Horn switch (optional)
- 3.3.10. Power TakeOff (PTO) switch
- 3.3.11. Key switch
- 3.3.12. Differential lock lever Operating
- 3.3.13. Hydrostatic transmission pedal Operating
- 3.3.14. Tilt steering lever Operating
- 3.3.15. Multifunction light switch
- 3.3.16. Constant Engine Speed (CES) switch
- 3.3.17. Constant Engine Speed (CES) Up / Down switch
- 3.3.18. DPF switch
- 3.4. Lefthand side controls
- 3.4.1. Transmission range lever
- 3.4.2. Park brake
- 3.4.3. FourWheel Drive(4WD) lever
- 3.4.4. Mid Power TakeOff (PTO) (optional)
- 3.5. Righthand side controls
- 3.5.1. Hydraulic Power Lift (HPL)
- 3.5.2. Rear remote control valve(s) optional
- 3.5.3. Midmount control valve
- 3.5.4. Mechanical transmission lever
- 3.6. Exterior controls
- 3.6.1. Hood release latch
- 4. OPERATING INSTRUCTIONS
- 4.1. Commissioning the unit
- 4.1.1. Engine breakin procedure
- 4.1.2. Diesel Particulate Filter (DPF) regeneration
- 4.1.3. Constant engine speed
- 4.1.4. Power TakeOff (PTO) operation
- 4.1.5. Threepoint hitch
- 4.1.6. Attaching threepoint equipment
- 4.1.7. Drawbar Operating
- 4.1.8. Top link installation
- 4.1.9. Drop rate control valve
- 4.2. Starting the unit
- 4.2.1. Key switch Operating
- 4.2.2. Glow plugs Cold start aid
- 4.2.3. Starting the engine (Mechanical)
- 4.2.4. Starting the engine (Hydrostatic transmission)
- 4.2.5. Starting the engine with jumper cables
- 4.3. Stopping the unit
- 4.3.1. Stopping the engine
- 4.3.2. Emergency stopping the engine
- 4.3.3. Brakes
- 4.4. Moving the unit
- 4.4.1. Steering wheel Adjust
- 4.4.2. Steering Operation
- 4.4.3. Transmission Warmup
- 4.4.4. Hydrostatic transmission Operation
- 4.4.5. Mechanical transmission external controls Operation
- 4.5. Parking the unit
- 4.5.1. Parking the tractor
- 5. TRANSPORT OPERATIONS
- 5.1. Road transport
- 5.1.1. External lighting
- 5.1.2. Turn signal / Hazard lights Identification
- 5.1.3. Road lights Operation
- 5.1.4. Work lights Operation
- 5.1.5. External lighting Operation (optional)
- 5.1.6. Brakes and controls Driving
- 5.2. Shipping transport
- 5.2.1. Transporting by truck or trailer
- 5.3. Recovery transport
- 5.3.1. Brakes and controls Towing
- 6. WORKING OPERATIONS
- 6.1. General information
- 6.1.1. Ballast
- 6.1.2. Ballast weight requirements
- 7. MAINTENANCE
- 7.1. General information
- 7.1.1. General information
- 7.1.2. General specification Diesel fuel
- 7.1.3. General specification Biodiesel fuels
- 7.1.4. Refueling the tractor
- 7.1.5. Change engine coolant to Organic Acid Technology (OAT) coolant
- 7.1.6. Fluids and lubricants
- 7.1.7. Capacities
- 7.2. Maintenance planning
- 7.2.1. Maintenance chart
- 7.3. Every 10 hours or daily
- 7.3.1. Engine oil level Check
- 7.3.2. Engine cooling system Check
- 7.4. After first 50 hours
- 7.4.1. Engine oil and oil filter Change
- 7.4.2. Hydraulic oil filter Replace
- 7.4.3. Hydrostatic transmission oil filter Replace
- 7.4.4. Roll Over Protective Structure (ROPS) Check
- 7.4.5. Wheels Bolts and Nuts Tighten
- 7.4.6. Fuel water seperator filter Replace
- 7.5. Every 50 hours
- 7.5.1. Grease fittings Lubricate
- 7.5.2. Transmission fluid level Check
- 7.5.3. Clutch pedal free play Adjust
- 7.5.4. Brake pedal free play Adjust
- 7.5.5. Hydrostatic Transmission (HST) neutral position Check and Adjust
- 7.5.6. Tire inflation pressure Check
- 7.5.7. Front axle and differential oil level Check
- 7.5.8. Air cleaner Clean Primary element
- 7.6. Every 100 hours
- 7.6.1. Fuel filter Drain
- 7.7. Every 300 hours
- 7.7.1. Engine oil and oil filter Change
- 7.7.2. Oil filter Replace
- 7.7.3. Hydrostatic Transmission (HST) oil filter Replace HST system
- 7.7.4. Wheel bolts and nuts Check
- 7.7.5. Air cleaner primary element Replace
- 7.8. Every 500 hours
- 7.8.1. Fuel filter water separator Replace
- 7.9. Every 600 hours
- 7.9.1. Front axle and differential fluid Change
- 7.9.2. Transmission fluid Change
- 7.10. Every 1000 hours
- 7.10.1. Air cleaner inner element Replace
- 7.11. Every 1500 hours
- 7.11.1. Engine coolant Draining and flushing
- 7.12. General maintenance
- 7.12.1. Fuel water separator filter Bleed
- 7.12.2. Hydrostatic transmission (HST) neutral adjustment Check
- 7.12.3. Engine belts Adjust
- 7.12.4. Roll Over Protective Structure (ROPS) Replace Possible damage
- 7.12.5. Battery
- 7.12.6. Alternator
- 7.12.7. Headlight bulb Replace
- 7.12.8. Turn signal/Hazard light bulb replacement
- 7.12.9. Flasher unit bulb Replace
- 7.12.10. Wheels Bolts and Nuts Tighten
- 7.12.11. Front wheel toein Adjust
- 7.12.12. Brake pedal free play Adjust
- 7.12.13. Clutch pedal free play Adjust
- 7.13. Fuse and relay locations
- 7.13.1. Fuse and relay locations
- 7.14. Storage
- 7.14.1. Tractor storage
- 7.14.2. Removal of the tractor from storage
- 8. TROUBLESHOOTING
- 8.1. Symptom(s)
- 8.1.1. Engine Troubleshooting
- 8.1.2. Hydraulic Lift System Troubleshooting
- 8.1.3. Steering Troubleshooting
- 8.1.4. Hydrostatic transmission Troubleshooting
- 8.1.5. Electrical system Troubleshooting
- 9. SPECIFICATIONS
- 9.1. Tire inflation pressures
- 9.2. Rear wheel liquid ballast
- 9.3. General specification
- 9.4. Dimensions
- 10. ACCESSORIES
- 10.1. Accessories
- 11. FORMS AND DECLARATIONS
- 11.1. Delivery report owner copy
- 11.2. Delivery report dealer copy








