Case Farmall 110U, 120U Tractor Operator Manual 51517462 PDF

Description

• Model List:
  • Farmall 110U Tractor
  • Farmall 120U Tractor

• 1. GENERAL INFORMATION
• 1.1. Note to the owner
• 1.2. Intended use
• 1.3. ElectroMagnetic Compatibility (EMC)
• 1.4. Manual scope and required training level
• 1.5. Metric and imperial units abbreviations
• 1.6. Identification plates
• 1.7. Operators manual storage on the machine
• 1.8. Machine orientation
• 1.9. Selective Catalytic Reduction (SCR) exhaust treatment Overview
• 2. SAFETY INFORMATION
• 2.1. Safety rules and signal word definitions
• 2.2. Safety rules General information
• 2.3. Safety rules Maintenance
• 2.4. Safety rules Wheels and tires
• 2.5. Safety rules Driving on public roads and transportation in general
• 2.6. Safety rules Explosions and fires
• 2.7. Safety rules Battery
• 2.8. Safety rules Instructor seat
• 2.9. Safety rules Operator presence system
• 2.10. Safety rules Power TakeOff (PTO)
• 2.11. Safety rules Reflectors and warning lights
• 2.12. Safety rules Seat belts
• 2.13. Safety rules Operator protective structure
• 2.14. Safety rules HVAC system
• 2.15. Safety rules Personal Protective Equipment (PPE)
• 2.16. Safety rules Do not use sign
• 2.17. Safety rules Hazardous chemicals
• 2.18. Safety rules Near utilities
• 2.19. Safety rules In the event of electrical storms
• 2.20. Safety rules Mounting and dismounting the machine
• 2.21. Safety rules Lifting and overhead loads
• 2.22. Safety rules Front end loader
• 2.23. Ecology and the environment
• 2.24. Towing the tractor for recovery
• 2.25. Tractor jacking points
• 2.26. Burn prevention
• 2.27. Safety signs
• 3. CONTROLS AND INSTRUMENTS
• 3.1. Access to operators platform
• 3.2. Operators seat
• 3.3. Instructional seat
• 3.4. Forward controls
• 3.5. Lefthand side controls
• 3.6. Righthand side controls
• 3.7. Overhead controls
• 3.8. Exterior controls
• 3.9. Display
• 3.10. Warning and advisory symbols
• 4. OPERATING INSTRUCTIONS
• 4.1. Commissioning the unit
• 4.2. Starting the unit
• 4.3. Stopping the unit
• 4.4. Moving the unit
• 5. TRANSPORT OPERATIONS
• 5.1. Road transport
• 5.2. Recovery transport
• 6. WORKING OPERATIONS
• 6.1. General information
• 6.2. Transmission
• 6.3. Rear remote control valves
• 6.4. Midmount control valve
• 6.5. Rear Power TakeOff (PTO)
• 6.6. Front Power TakeOff (PTO)
• 6.7. Rear hydraulic lift
• 6.8. Front hydraulic lift
• 6.9. Rear threepoint hitch
• 6.10. Threepoint hitch front
• 6.11. Towbar
• 6.12. Wheels and tires
• 6.13. Tread and fender settings
• 7. MAINTENANCE
• 7.1. General information
• 7.2. Maintenance planning
• 7.3. As required
• 7.4. At warning message display
• 7.5. Every 10 hours or daily
• 7.6. After the first 50 hours of operation
• 7.7. Every 50 hours
• 7.8. Every 100 hours
• 7.9. Every 300 hours
• 7.10. Every 600 hours
• 7.11. Every 1200 hours or annually
• 7.12. Every 1200 hours or two years
• 7.13. Every two years
• 7.14. Every 3600 hours or two years
• 7.15. Every 3600 hours or four years
• 7.16. Electrical system
• 7.17. Fuse and relay locations
• 7.18. Storage
• 7.19. Calibration
• 8. TROUBLESHOOTING
• 8.1. Fault code resolution
• 8.2. Symptom(s)
• 9. SPECIFICATIONS
• 9.1. General dimensions
• 9.2. Maximum permitted loads on front and rear axle
• 9.3. x 16 transmission speed table
• 9.4. x 32 transmission speed table
• 9.5. Additional equipment attachment points
• 9.6. Additional equipment attachment points
• 9.7. Front loader support
• 9.8. Backup alarm and light