Case Farmall 35A, 40A Tier 4B (Final) Tractor Operator Manual 51485754 PDF

Description

• Model List:
  • Farmall 35A Tier 4B (Final) Tractor
  • Farmall 40A Tier 4B (Final) Tractor

• 1. GENERAL INFORMATION
• 1.1. Note to the owner
• 1.2. Intended use
• 1.3. Electromagnetic Compatibility (EMC)
• 1.4. Product identification
• 1.5. Operators manual storage
• 1.6. Machine orientation
• 1.7. Emissions overview
• 2. SAFETY INFORMATION
• 2.1. Safety rules and signal word definitions
• 2.2. Safety rules
• 2.3. Do not operate tag
• 2.4. Roll Over Protective Structure (ROPS) frame Personal safety
• 2.5. Ecology and the environment
• 2.6. Safety signs
• 2.7. Instructional signs
• 2.8. Safety features
• 3. CONTROLS AND INSTRUMENTS
• 3.1. Access to operators platform
• 3.1.1. Access to operators platform
• 3.2. Operators seat
• 3.2.1. Seat belt
• 3.2.2. Mechanically adjusted operator seat
• 3.2.3. Roll Over Protective Structure (ROPS)
• 3.3. Forward controls
• 3.3.1. Instrument panel
• 3.3.2. Engine fault code display
• 3.3.3. Hydrostatic transmission Operate
• 3.3.4. Shuttle lever
• 3.3.5. Clutch pedal
• 3.3.6. Brake pedal
• 3.3.7. Foot throttle pedal
• 3.3.8. Hand throttle lever
• 3.3.9. Horn switch (optional)
• 3.3.10. Power TakeOff (PTO) switch
• 3.3.11. Key switch
• 3.3.12. Differential lock lever Operating
• 3.3.13. Hydrostatic transmission pedal Operating
• 3.3.14. Tilt steering lever Operating
• 3.3.15. Multifunction light switch
• 3.3.16. Constant Engine Speed (CES) switch
• 3.3.17. Constant Engine Speed (CES) Up / Down switch
• 3.3.18. DPF switch
• 3.4. Lefthand side controls
• 3.4.1. Transmission range lever
• 3.4.2. Park brake
• 3.4.3. FourWheel Drive(4WD) lever
• 3.4.4. Mid Power TakeOff (PTO) (optional)
• 3.5. Righthand side controls
• 3.5.1. Hydraulic Power Lift (HPL)
• 3.5.2. Rear remote control valve(s) optional
• 3.5.3. Midmount control valve
• 3.5.4. Mechanical transmission lever
• 3.6. Exterior controls
• 3.6.1. Hood release latch
• 4. OPERATING INSTRUCTIONS
• 4.1. Commissioning the unit
• 4.1.1. Engine breakin procedure
• 4.1.2. Diesel Particulate Filter (DPF) regeneration
• 4.1.3. Constant engine speed
• 4.1.4. Power TakeOff (PTO) operation
• 4.1.5. Threepoint hitch
• 4.1.6. Attaching threepoint equipment
• 4.1.7. Drawbar Operating
• 4.1.8. Top link installation
• 4.1.9. Drop rate control valve
• 4.2. Starting the unit
• 4.2.1. Key switch Operating
• 4.2.2. Glow plugs Cold start aid
• 4.2.3. Starting the engine (Mechanical)
• 4.2.4. Starting the engine (Hydrostatic transmission)
• 4.2.5. Starting the engine with jumper cables
• 4.3. Stopping the unit
• 4.3.1. Stopping the engine
• 4.3.2. Emergency stopping the engine
• 4.3.3. Brakes
• 4.4. Moving the unit
• 4.4.1. Steering wheel Adjust
• 4.4.2. Steering Operation
• 4.4.3. Transmission Warmup
• 4.4.4. Hydrostatic transmission Operation
• 4.4.5. Mechanical transmission external controls Operation
• 4.5. Parking the unit
• 4.5.1. Parking the tractor
• 5. TRANSPORT OPERATIONS
• 5.1. Road transport
• 5.1.1. External lighting
• 5.1.2. Turn signal / Hazard lights Identification
• 5.1.3. Road lights Operation
• 5.1.4. Work lights Operation
• 5.1.5. External lighting Operation (optional)
• 5.1.6. Brakes and controls Driving
• 5.2. Shipping transport
• 5.2.1. Transporting by truck or trailer
• 5.3. Recovery transport
• 5.3.1. Brakes and controls Towing
• 6. WORKING OPERATIONS
• 6.1. General information
• 6.1.1. Ballast
• 6.1.2. Ballast weight requirements
• 7. MAINTENANCE
• 7.1. General information
• 7.1.1. General information
• 7.1.2. General specification Diesel fuel
• 7.1.3. General specification Biodiesel fuels
• 7.1.4. Refueling the tractor
• 7.1.5. Change engine coolant to Organic Acid Technology (OAT) coolant
• 7.1.6. Fluids and lubricants
• 7.1.7. Capacities
• 7.2. Maintenance planning
• 7.2.1. Maintenance chart
• 7.3. Every 10 hours or daily
• 7.3.1. Engine oil level Check
• 7.3.2. Engine cooling system Check
• 7.4. After first 50 hours
• 7.4.1. Engine oil and oil filter Change
• 7.4.2. Hydraulic oil filter Replace
• 7.4.3. Hydrostatic transmission oil filter Replace
• 7.4.4. Roll Over Protective Structure (ROPS) Check
• 7.4.5. Wheels Bolts and Nuts Tighten
• 7.4.6. Fuel water seperator filter Replace
• 7.5. Every 50 hours
• 7.5.1. Grease fittings Lubricate
• 7.5.2. Transmission fluid level Check
• 7.5.3. Clutch pedal free play Adjust
• 7.5.4. Brake pedal free play Adjust
• 7.5.5. Hydrostatic Transmission (HST) neutral position Check and Adjust
• 7.5.6. Tire inflation pressure Check
• 7.5.7. Front axle and differential oil level Check
• 7.5.8. Air cleaner Clean Primary element
• 7.6. Every 100 hours
• 7.6.1. Fuel filter Drain
• 7.7. Every 300 hours
• 7.7.1. Engine oil and oil filter Change
• 7.7.2. Oil filter Replace
• 7.7.3. Hydrostatic Transmission (HST) oil filter Replace HST system
• 7.7.4. Wheel bolts and nuts Check
• 7.7.5. Air cleaner primary element Replace
• 7.8. Every 500 hours
• 7.8.1. Fuel filter water separator Replace
• 7.9. Every 600 hours
• 7.9.1. Front axle and differential fluid Change
• 7.9.2. Transmission fluid Change
• 7.10. Every 1000 hours
• 7.10.1. Air cleaner inner element Replace
• 7.11. Every 1500 hours
• 7.11.1. Engine coolant Draining and flushing
• 7.12. General maintenance
• 7.12.1. Fuel water separator filter Bleed
• 7.12.2. Hydrostatic transmission (HST) neutral adjustment Check
• 7.12.3. Engine belts Adjust
• 7.12.4. Roll Over Protective Structure (ROPS) Replace Possible damage
• 7.12.5. Battery
• 7.12.6. Alternator
• 7.12.7. Headlight bulb Replace
• 7.12.8. Turn signal/Hazard light bulb replacement
• 7.12.9. Flasher unit bulb Replace
• 7.12.10. Wheels Bolts and Nuts Tighten
• 7.12.11. Front wheel toein Adjust
• 7.12.12. Brake pedal free play Adjust
• 7.12.13. Clutch pedal free play Adjust
• 7.13. Fuse and relay locations
• 7.13.1. Fuse and relay locations
• 7.14. Storage
• 7.14.1. Tractor storage
• 7.14.2. Removal of the tractor from storage
• 8. TROUBLESHOOTING
• 8.1. Symptom(s)
• 8.1.1. Engine Troubleshooting
• 8.1.2. Hydraulic Lift System Troubleshooting
• 8.1.3. Steering Troubleshooting
• 8.1.4. Hydrostatic transmission Troubleshooting
• 8.1.5. Electrical system Troubleshooting
• 9. SPECIFICATIONS
• 9.1. Tire inflation pressures
• 9.2. Rear wheel liquid ballast
• 9.3. General specification
• 9.4. Dimensions
• 10. ACCESSORIES
• 10.1. Accessories
• 11. FORMS AND DECLARATIONS
• 11.1. Delivery report owner copy
• 11.2. Delivery report dealer copy