Case JX55T, JX75T Tractor Operator Manual 48134824 PDF

Description

• Model List:
  • JX55T Tractor
  • JX75T Tractor

• 1. GENERAL INFORMATION
• 1.1. General information and safety
• 1.2. Product identification
• 1.3. Ecology and the Environment
• 2. SAFETY INFORMATION
• 2.1. Safety rules
• 2.2. Personal safety
• 2.3. Driving the tractor
• 2.4. Operating the tractor
• 2.5. Operating the Power TakeOff (PTO)
• 2.6. Servicing the tractor
• 2.7. Diesel fuel
• 2.8. Instructions for driving on road
• 2.9. International symbols
• 2.10. Fuel saving tips for optimum performance
• 2.11. Trailer hitching
• 2.12. General and Safety Decals
• 3. CONTROLS AND INSTRUMENTS
• 3.1. Access to operators platform
• 3.1.1. Before operating
• 3.2. Operators seat
• 3.2.1. Operator seat Adjust
• 3.2.2. Seat belt (If equipped)
• 3.3. Forward controls
• 3.3.1. Instrument cluster Control identification
• 3.3.2. Hand controls and switches
• 3.4. Lefthand side controls
• 3.4.1. Clutch
• 3.4.2. Creeper gears (If equipped)
• 3.4.3. Power TakeOff (PTO)
• 3.4.4. D Lever
• 3.5. Righthand side controls
• 3.5.1. Foot Accelerator
• 3.5.2. Differential lock pedal
• 3.5.3. Brake pedal
• 3.5.4. Parking Brake
• 3.6. Transmission
• 3.6.1. Transmission
• 3.6.2. Transmission speeds
• 4. OPERATING INSTRUCTIONS
• 4.1. Commissioning the unit
• 4.1.1. Before operating
• 4.1.2. RunningIn Procedure
• 4.2. Starting the unit
• 4.2.1. Starting the tractor with jumper cables
• 4.2.2. Starting the engine
• 4.3. Stopping the unit
• 4.3.1. Stopping the engine
• 5. TRANSPORT OPERATIONS
• 5.1. Road transport
• 5.1.1. Carrying the tractor on a transporter
• 5.2. Recovery transport
• 5.2.1. Towing the tractor
• 6. WORKING OPERATIONS
• 6.1. POWER TAKE OFF (PTO)
• 6.1.1. Power TakeOff (PTO) operating precautions
• 6.1.2. Attaching PTO driven equipment
• 6.1.3. Connecting the Power TakeOff (PTO)
• 6.1.4. Power TakeOff (PTO) protective cap and guard
• 6.1.5. Power TakeOff (PTO) Operating
• 6.1.6. Ground speed PTO
• 6.2. THREEPOINT LINKAGE
• 6.2.1. Threepoint linkage
• 6.2.2. Attaching 3point implements
• 6.2.3. Lift rods, lower links and top link
• 6.2.4. Remote control valves
• 6.2.5. Auxiliary hydraulic valve
• 6.2.6. Towing attachments
• 6.3. HYDRAULIC SYSTEM
• 6.3.1. Hydraulic system
• 6.3.2. Position control operation
• 6.3.3. Draft Control Operation
• 6.3.4. Combined position and Draft control Mixed Control
• 6.3.5. Float Operation
• 6.3.6. LiftOMatic Button
• 6.3.7. Height Limiter Lift OMatic (If equipped)
• 6.3.8. Sensitivity Control
• 6.3.9. Response Control or Drop rate Control
• 6.3.10. Tapoff valve and external supply port
• 6.4. WHEEL TRACK ADJUSTMENT
• 6.4.1. Front axle system Adjust
• 6.4.2. Track Rod Hydrostatic Steering Right side illustrated
• 6.4.3. Reassembly After Setting Track Width
• 6.4.4. Front wheel track adjustment 4WD
• 6.4.5. Front wheels toein
• 6.4.6. Rear wheel track adjustment
• 6.5. BALLASTING AND TIRES
• 6.5.1. Ballasting of Tires Selecting ballast
• 6.5.2. Rear wheel ballast weights
• 6.6. General information
• 6.6.1. Introduction
• 6.6.2. Safety precautions
• 6.6.3. During the first 50 hour operation
• 6.6.4. The First 50 Hours Service
• 6.6.5. Preventing System Contamination
• 6.6.6. Flexibility of Maintenance Intervals
• 6.6.7. Lubrication and maintenance chart
• 6.6.8. Fueling the tractor
• 6.6.9. General specification
• 6.6.10. Fuel storage
• 6.6.11. Guards
• 6.7. Maintenance planning
• 6.7.1. Maintenance Maintenance chart
• 6.8. EVERY 10 HOURS OF OPERATION OR DAILY
• 6.8.1. Check engine oil level
• 6.8.2. Radiator coolant level check
• 6.8.3. Air precleaner Cleaning
• 6.8.4. Hydrostatic steering oil level
• 6.8.5. Fuel filters Drain fluid
• 6.8.6. Fuelwater separator filter Cleaning
• 6.9. EVERY 50 HOURS
• 6.9.1. Clutch Pedal Free Play Check
• 6.9.2. Brake pedals Adjust
• 6.9.3. Parking brake or parking lock Check
• 6.9.4. Wheel hub Check
• 6.9.5. Tire Pressures and Condition Tyre Pressures and Condition
• 6.9.6. Fan/alternator belt adjustment
• 6.9.7. Grease fittings
• 6.9.8. Battery Check
• 6.9.9. FourWheel Drive (4WD) axle Check
• 6.10. EVERY 300 HOURS
• 6.10.1. Air cleaner Cleaning
• 6.10.2. Fuel filters Replace
• 6.10.3. Fuel Feed Pump Filter
• 6.10.4. Hydrostatic steering oil filter
• 6.10.5. Engine Change fluid
• 6.10.6. Engine oil filter Replace
• 6.10.7. Transmission/hydraulics oil level
• 6.10.8. Hydraulic filter cleaning
• 6.10.9. Front Axle Reduction Hubs 4WD
• 6.10.10. D front axle swivel bearings
• 6.10.11. Drive Shaft Sleeve for 4WD Front Axle Connection
• 6.10.12. PTO clutch lever free play
• 6.11. EVERY 600 HOURS
• 6.11.1. Fuel filters Replace
• 6.11.2. Camshaft Tappets Adjust
• 6.11.3. Transmission oil vapor breather clean
• 6.11.4. Clean, Regrease and Adjust Front Wheel Bearings
• 6.11.5. Service Fuel Injectors
• 6.11.6. Front wheel toein adjust
• 6.12. EVERY 1200 HOURS
• 6.12.1. Change Transmission/Hydraulics Oil
• 6.12.2. Change the final drive oil
• 6.12.3. Radiator Drain fluid
• 6.12.4. Steering oil reservoir change fluid
• 6.12.5. Front Axle Housing Oil Level 4WD
• 6.12.6. Draining the Oil from the Front Axle Final Drives 4WD
• 6.12.7. Final drive 4 WD
• 6.12.8. Fuel tanks Cleaning
• 6.13. GENERAL MAINTENANCE
• 6.13.1. Fuel injection system Bleed
• 6.13.2. Engine idle speed
• 6.13.3. Headlight Adjust
• 6.13.4. Work light Adjust
• 6.13.5. Stop/Turn/Position Lights
• 6.13.6. Canopy lights Adjust
• 6.13.7. Fuse replacement
• 6.13.8. Electrical systems Charging
• 6.14. Storage
• 6.14.1. Vehicle Storage
• 7. TROUBLESHOOTING
• 7.1. Fault code resolution
• 7.1.1. Maintenance Troubleshooting
• 8. SPECIFICATIONS
• 8.1. General specifications
• 8.2. Engine Technical Data
• 8.3. Engine cooling system General specification
• 8.4. Clutch Technical Data
• 8.5. Power TakeOff (PTO) Technical Data
• 8.6. Rear threepoint hitch linkage Technical Data
• 8.7. Hydraulic systems Technical Data
• 8.8. Electrical system Technical Data
• 8.9. Steering Technical Data
• 8.10. Brakes and controls Technical Data
• 8.11. Maintenance General specification