John Deere 401D Utility Construction Tractor Backhoe Loader Technical Manual TM1271 PDF

Description

Details:

1. SECTION 1 – GENERAL INFORMATION
2. Group 1 – Introduction and Safety Information
3. Group II – General Specifications
4. Group III – Torque Values
5. Group IV – Fuels and Lubricants
6. SECTION 01 – WHEELS
7. Group 0110 – Powered Wheels and Fastenings
8. Group 0120 – Non-Powered Wheels and Fastenings
9. Group 0149 – Weights
10. SECTION 02 – AXLES AND SUSPENSION SYSTEMS
11. Group 0230 – Non-Powered Wheel Axles
12. Group 0250 – Axle Shafts, Bearings and Reduction Gears
13. SECTION 03 – TRANSMISSION
14. Group 0300 – Removal and Installation
15. Group 0315 – Controls
16. Group 0350 – Gears, Shafts, Bearings and Power Shift Clutch
17. Group 0360 – Hydraulic System
18. SECTION 04 – ENGINE
19. Group 0400 – Removal and Installation
20. Group 0401 – Crankshaft and Main Bearings
21. Group 0402 – Camshaft and Valve Actuating Means
22. Group 0403 – Connecting Rods and Pistons
23. Group 0404 – Cylinder Block
24. SECTION 04 – ENGINE – Continued
25. Group 0407 – Oiling System
26. Group 0409 – Cylinder Head and Valves
27. Group 0413 – Fuel Injection System
28. Group 0414 – Intake Manifold
29. Group 0415 – Engine Balancer
30. Group 0417 – Water Pump
31. Group 0418 – Thermostats, Housing and Piping
32. Group 0419 – Oil Cooler
33. Group 0420 – Fuel Filter
34. Group 042I – Fuel Transfer Pump
35. Group 0422 – Starting Motor and Fastenings
36. Group 0433 – Flywheel, Housing and Fastenings
37. SECTION 05 – ENGINE AUXILIARY SYSTEMS
38. Group 0505 – Cold Weather Starting Aids
39. Group 0510 – Cooling Systems
40. Group 0515 – Speed Controls
41. Group 0520 – Intake System
42. Group 0530 – External Exhaust Systems
43. Group 0560 – External FuelSupply Systems
44. SECTION 07 – TRACTION CLUTCH
45. Group 0715 – Controls
46. Group 0752 – Elements
47. SECTION 09 – STEERING SYSTEM
48. Group 0960 – Hydraulic System
49. SECTION 10 – SERVICE BRAKES
50. Group 1011 – Active Elements
51. Group 1060 – Hydraulic System
52. SECTION 11 – PARKING-EMERGENCY BRAKES
53. Group 1111 – Active Elements
54. Group 1115 – Controls Linkage
55. SECTION 15 – EQUIPMENT ATTACHING
56. Group 1520 – Hitches and Hitch Pins
57. SECTION 16 – ELECTRICAL SYSTEMS
58. Group 1671 – Batteries, Support and Cables
59. Group 1672 – Alternator, Regulator and Charging System Wiring
60. Group 1673 – Lighting System
61. Group 1674 – Wiring Harness and Switches
62. Group 1676 – Instruments and Indicators
63. SECTION 18 – Operator STATION
64. Group 1800 – Renroval and installation
65. SECTION 21 – MAIN HYDRAULIC SYSTEM
66. Group 2160 – Hydraulic System
67. SECTION 31 – LOADER
68. Group 3102 – Bucket (Including Teeth and Cutting Edge)
69. Group 3115 – Controls Linkage
70. Group 3140 – Frames
71. Group 3160 – Loader Hydraulics
72. SECTION 33 – BACKHOE EXCAVATOR
73. Group 3300 – Removal and Installation
74. Group 3302 – Buckets, Teeth, Shanks and Sidecutters
75. Group 3315 – Controls Linkage
76. Group 3340 – Frames
77. Group 3360 – Hydraulic System
78. SECTION 40 – PTO OR WINCH DRIVE
79. Group 4015 – PTO Control
80. Group 4051 – Gears, Shafts, and Bearings
81. Group 4052 – PTO Clutch (If Separate)
82. Group 4060 – Hydraulic System
83. SECTION 90 – SYSTEM TESTING
84. Group 9005 – General Information – Seven Basic Steps of Diagnosis and Testing
85. Group 9010 – Engine
86. Group 9015 – Electrical System
87. Group 9020 – Power Train
88. Group 9025 – Hydraulic System
89. SECTION 99 – SPECIAL TOOLS
90. INDEX