John Deere 5603 Tractors Operator Manual OMRE267253

Description

• Model List:
  • 5603 Tractor

• 1. Contents
• 1.0.1. Recognize Safety Information
• 1.0.2. Understand Signal Words
• 1.0.3. Follow Safety Instructions
• 1.0.4. Practice Safe Maintenance
• 1.0.5. Keep ROPS Installed Properly
• 1.0.6. Service Tires Safely
• 1.0.7. Avoid HighPressure Fluids
• 1.0.8. Support Machine Properly
• 1.0.9. Service Tractor Safely
• 1.0.10. Work In Ventilated Area
• 1.0.11. Remove Paint Before Welding or Heating
• 1.0.12. Service Cooling System Safely
• 1.0.13. Avoid Heating Near Pressurized Fluid Lines
• 1.0.14. Decommissioning Proper Recycling and Disposal of Fluids and Components
• 1.1. Maintenance and Service Intervals
• 1.1.1. Maintenance and Service Intervals
• 1.1.2. BreakIn Service
• 1.1.3. Service Interval Chart
• 1.1.4. Service Interval Chart
• 1.1.5. ServiceAs Required
• 1.2. MaintenanceAs Required
• 1.2.1. Adjusting Hand Throttle Friction
• 1.2.2. Adjusting 540/540E PTO Lever and Linkage
• 1.2.3. Servicing Air Conditioner
• 1.2.4. Inspecting Fuel Injectors
• 1.2.5. Replacing InLine Fuel Filter
• 1.2.6. Cleaning and Checking Battery
• 1.2.7. Lubricating Front Axle Pivot Pin
• 1.2.8. Checking Brakes
• 1.2.9. Lubricating Hood Latch
• 1.3. MaintenanceEvery 10 Hours or Daily
• 1.3.1. Checking Engine Oil Level
• 1.3.2. Drain Water and Sediment from Fuel Tank and Fuel Filter
• 1.4. MaintenanceEvery Week or 50 Hours
• 1.4.1. Checking Coolant Level
• 1.4.2. Checking TransmissionHydraulic System Oil Level
• 1.4.3. Checking MFWD Axle Housing Oil Level
• 1.4.4. Checking MFWD Axle Wheel Hub Oil Level
• 1.4.5. Inspecting Tires
• 1.4.6. Lubricating Steering King Pins
• 1.4.7. Inspecting Tractor for Loose Hardware
• 1.5. MaintenanceFirst 100 Hours
• 1.5.1. Changing Engine Oil and Filter
• 1.5.2. Replacing TransmissionHydraulic Filter
• 1.6. MaintenanceEvery 300 Hours
• 1.6.1. Inspecting Air Cleaner Elements
• 1.6.2. Lubricating 3Point Hitch
• 1.6.3. Checking Neutral Start System
• 1.6.4. Cleaning Cab Air Filters
• 1.6.5. Adjusting PTO Clutch Lever Linkage
• 1.6.6. Replacing Fuel Filter
• 1.7. MaintenanceEvery 600 Hours
• 1.7.1. Replacing TransmissionHydraulic Filter
• 1.7.2. Changing MFWD Axle Wheel Hub Oil
• 1.7.3. Changing MFWD Axle Housing Oil
• 1.7.4. Cleaning Engine Crankcase Vent Tube
• 1.7.5. Check Engine Cooling System
• 1.7.6. Lubricating Rear Axle Bearings
• 1.7.7. Checking Engine Idle Speeds
• 1.7.8. Checking Front Axle Pivot Pin End Play
• 1.7.9. Changing Engine Oil and Filter
• 1.8. MaintenanceEvery 1200 Hours
• 1.8.1. Changing TransmissionHydraulic Oil and Filter
• 1.8.2. Cleaning TransmissionHydraulic Oil Pickup Screen
• 1.9. MaintenanceAnnually or 1800 Hours
• 1.9.1. Replacing Air Cleaner Elements
• 1.9.2. Inspecting Seat Belt
• 1.10. MaintenanceEvery 2100 Hours or Two Years
• 1.10.1. Flushing Cooling System and Replacing Thermostat
• 1.10.2. Adjusting Engine Valve Clearance
• 1.11. MaintenanceMiscellaneous
• 1.11.1. Cleaning Grille Screens, Radiator, Oil Cooler or A/C Condenser
• 1.11.2. Inspecting Fan Belt Tensioner
• 1.11.3. Replacing Fan Belt
• 1.11.4. Keeping Cab Protection System Installed Properly
• 1.11.5. Bleeding Fuel System
• 1.11.6. Replacing Battery
• 1.11.7. Locating Fusible Links
• 1.11.8. Locating Fuses
• 1.11.9. Fuse and Relay Size and Function
• 1.11.10. Handle Halogen Light Bulbs Safely
• 1.11.11. Replacing Headlight Bulb
• 1.11.12. Replacing Warning Light Bulb
• 1.11.13. Replacing Taillight Bulb
• 1.11.14. Replacing Work Light Bulb
• 1.11.15. Replacing Loader Light BulbIf Equipped
• 1.11.16. Replacing Dome Light Bulb
• 1.11.17. Replacing Controls Illumination Light Bulb
• 1.11.18. Replacing Rotary Beacon Light BulbIf Equipped
• 1.12. Wheels, Tires and Treads
• 1.12.1. Service Tires Safely
• 1.12.2. Check ImplementtoTire Clearance
• 1.12.3. Check Tire Inflation Pressure
• 1.12.4. Tire Inflation Pressure Charts
• 1.12.5. Selecting Front Tire Rolling Direction
• 1.12.6. Tighten Wheel/Axle Hardware Correctly
• 1.12.7. Tighten Wheel BoltsMFWD Axle
• 1.12.8. Tighten Wheel BoltsRear Axle
• 1.12.9. Observe Rear Wheel Tread Width Limitations
• 1.12.10. Tread SettingsMultiPosition Rear Wheels
• 1.12.11. Tread SettingsMultiPosition MFWD Wheels
• 1.12.12. Checking ToeInMFWD Axle
• 1.12.13. Adjusting ToeInMFWD Axle
• 1.12.14. Set MFWD Steering Stops Turning Radius
• 1.12.15. Use Correct Tire Combinations
• 1.13. Fuel, Lubricants, and Coolant
• 1.13.1. Diesel Fuel
• 1.13.2. Handling and Storing Diesel Fuel
• 1.13.3. Lubricity of Diesel Fuel
• 1.13.4. Testing Diesel Fuel
• 1.13.5. Biodiesel Fuel
• 1.13.6. Filling Fuel Tank
• 1.13.7. Diesel Engine BreakIn Oil NonEmissions Certified and Certified Tier 1, Tier 2, Tier 3, Stage I, Stage II, and Stage III
• 1.13.8. Diesel Engine Oil NonEmissions Certified and Certified Tier 1 and Stage I
• 1.13.9. Oil Filters
• 1.13.10. Diesel Engine Coolant (engine with wet sleeve cylinder liners)
• 1.13.11. Operating in Warm Temperature Climates
• 1.13.12. Testing Diesel Engine Coolant
• 1.13.13. Transmission and Hydraulic Oil
• 1.13.14. Use Correct TransmissionHydraulic Filter Element
• 1.13.15. MFWD Axle Housing and Wheel Hub Oil
• 1.13.16. Multipurpose Extreme Pressure (EP) Grease
• 1.13.17. Mixing of Lubricants
• 1.13.18. Alternative and Synthetic Lubricants
• 1.13.19. Lubricant Storage
• 1.14. Service and Maintenance Record
• 1.14.1. First 100 Hour Service
• 1.14.2. Hour Service
• 1.14.3. Hour Service
• 1.14.4. Hour Service
• 1.14.5. Hour Service
• 1.14.6. Hour Service
• 1.14.7. Hour or Annual Service
• 1.14.8. Hour/Two Years Service
• 1.14.9. Change of Ownership
• 1.14.10. Change of Ownership
• 1.14.11. Change of Ownership
• 2. Page Number
• 2.1. Section 05
• 2.2. Section 10
• 2.3. Section 15
• 2.4. Section 20
• 2.5. Section 25
• 2.6. Section 30
• 2.7. Section 40
• 2.8. Section 45
• 2.9. Section 50
• 2.10. Section 55
• 2.11. Section 60
• 2.12. Section 65
• 2.13. Section 70
• 2.14. Section 75
• 2.15. Section 80