Description
-
Model List:
- 1050R Skid-Steer Loader
- 1050R (EU) Skid-Steer Loader
- 1050R X-Series Skid-Steer Loader
- 1. SkidSteer Loader Operators Manual
- 2. AllTach and Hydraloc are trademarks of Manitou Group.
- 3. Introduction
- 3.1. Loader Identification
- 3.2. Control/Indicator Symbols
- 3.3. Power Off
- 3.4. Power On
- 3.5. Engine Start
- 3.6. Battery Charge
- 3.7. Electrical Power
- 3.8. Worklight w/Tail Lights
- 3.9. Worklight
- 3.10. Safety Alert
- 3.11. Hazard Flasher
- 3.12. Fasten Seatbelt
- 3.13. Horn
- 3.14. Read Operators Manual
- 3.15. Volume Full
- 3.16. Volume Half Full
- 3.17. Engine Air Filter
- 3.18. Engine Oil
- 3.19. Engine Oil Filter
- 3.20. Engine Oil Pressure
- 3.21. Fuel Filter
- 3.22. Engine Temperature
- 3.23. Hydraulic System
- 3.24. Hydraulic Oil Temperature
- 3.25. Hydraulic Oil Filter
- 3.26. Grease Lubrication Point
- 3.27. Glow Indicator Lamp
- 3.28. Diesel Fuel
- 3.29. Chaincase Oil
- 3.30. Clockwise Rotation
- 3.31. Counterclockwise Rotation
- 3.32. Fast
- 3.33. Slow
- 3.34. Ride Control
- 3.35. Engine Malfunction Shutdown
- 3.36. Bucket Float
- 3.37. Bucket Rollback
- 3.38. Bucket Dump
- 3.39. Lift Arm Lower
- 3.40. Lift Arm Raise
- 3.41. Service Hours
- 3.42. Battery Disconnect
- 3.43. DPF Service
- 3.44. Exhaust Gas Temperature
- 3.45. DPF Regen Acknowledgement
- 3.46. Service Interval
- 3.47. Low Fuel Alarm
- 3.48. Master Light Switch
- 3.49. Position Lights
- 3.50. Engine Speed Control
- 3.51. DPF Regen Inhibited
- 3.52. SelfLeveling
- 3.53. Unlock
- 3.54. Lift Point
- 3.55. Windshield Washer
- 3.56. Rear Washer
- 3.57. Windshield Wiper
- 3.58. Aftertreatment Error
- 4. Safety
- 4.1. Mandatory Safety Shutdown Procedure
- 4.2. Safety Reminders
- 4.3. Potential Hazards
- 4.4. Safety Decals
- 4.5. Safety Decals inside the ROPS/FOPS
- 4.6. Safety Decals on the outside of the Skid Loader
- 4.7. Safety Decals in the Engine Compartment
- 4.8. ISOStyle (used Internationally) Safety Decals inside the ROPS/FOPS
- 4.9. ISOStyle (used Internationally) Safety Decals on the outside of the SkidSteer Loader
- 4.10. ISOStyle (used Internationally) Safety Decals in the Engine Compartment
- 4.11. Product and Component Plate Locations
- 5. Controls and Safety Equipment
- 5.1. Guards and Shields
- 5.2. Operator Restraint Bar
- 5.3. Operators Seat
- 5.4. UpperTorso Restraint
- 5.5. Safety Interlock System
- 5.6. ROPS/FOPS
- 5.7. Parking Brake
- 5.8. Horn
- 5.9. Rear Window Emergency Exit
- 5.10. Lift Arm Support Device
- 5.11. Accessory Plug
- 5.12. Dome Light
- 5.13. Work Lights
- 5.14. Heater (optional)
- 5.15. Lockable Fuel Cap
- 5.16. Engine Speed Control
- 5.17. Float Control
- 5.18. Instrument Panel (DPF Models)
- 5.19. Instrument Panel (NonDPF Models)
- 5.20. TBar Controls
- 5.21. Hand/Foot Controls
- 5.22. Auxiliary Hydraulic Controls
- 5.23. Attachment Mounting
- 5.24. Electrical Battery Disconnect Switch (optional)
- 5.25. Information Center Electronic Display (DPF Models)
- 6. Operation
- 6.1. Before Starting the Engine
- 6.2. Fuel
- 6.3. Starting the Engine
- 6.4. ColdStarting
- 6.5. Cold Starting Procedure
- 6.6. Stopping the Loader
- 6.7. Parking the Loader
- 6.8. Jump Starting the Engine
- 6.9. Changing Attachments
- 6.10. SelfLeveling (optional)
- 6.11. Using a Bucket
- 6.12. Vibration Information
- 6.13. Vibration Measurement and Actions
- 6.14. Highway Travel
- 6.15. Lifting the Loader
- 6.16. Storing the Loader
- 6.17. Removing Loader from Storage
- 6.18. Transporting/Towing the Loader
- 6.19. Diesel Particulate Filter (DPF) Regeneration Procedures (DPF Models)
- 7. Notes
- 7.1. Service
- 7.2. Troubleshooting
- 7.3. Maintenance Schedule
- 7.4. Specifications
- 8. Blank Page
- 9. Blank Page
- 10. Blank Page
- 11. Blank Page
