Description
Introduction
Trademarks
Foreword
Contents
General Information
Safety
Recognize Safety Information
Follow Safety Instructions
Operate Only If Qualified
Wear Protective Equipment
Protect Against Noise
Avoid Unauthorized Attachment Modifications
Protect Against Flying Debris
Inspect Attachment
Stay Clear of Moving Parts
Avoid High-Pressure Oils and Fluids
Decommissioning — Proper Recycling and Disposal of Fluids and Components
Add Cab Guarding for Special Uses
Use Steps and Handholds Correctly
Start Only From Operator′s Seat
Prevent Unintended Machine Movement
Avoid Work Site Hazards
Keep Riders Off Attachment
Avoid Machine Tip Over
Add and Operate Attachments Safely
Use Special Care When Operating
Inspect and Maintain Demolition Guard
Remove Paint Before Welding or Heating
Make Welding Repairs Safely
Drive Metal Pins Safely
Practice Safe Maintenance
Use Proper Lifting Equipment
Specifications and Information
Inch Bolt Screws and Nut Torque Values
Metric Bolt and Screw Torque Values
Check Oil Lines and Fittings
Service Recommendations for O-Ring Boss Fittings
Straight Fitting
Angle Fitting
Service Recommendations For Flat Face O-Ring Seal Fittings
Service Recommendations for 37° Flare and 30° Cone Seat Connectors
Service Recommendations for Flared Connections—Straight or Tapered Threads
Service Recommendations For Inch Series Four Bolt Flange Fittings
Service Recommendations for Metric Series Four Bolt Flange Fitting
Hydraulic System British Standard Pipe (BSP) Fitting Torques
Cold Planer
Repair-CP18G, CP24G, CP30G, and CP40G
Hydraulic Motor and Drum Remove and Install—CP18G and CP24G
MACHINE PREPARATION
REMOVAL
INSTALLATION
Hydraulic Motor and Drum Remove and Install—CP30G
MACHINE PREPARATION
REMOVAL
INSTALLATION
Hydraulic Motor and Drum Remove and Install—CP40G
MACHINE PREPARATION
REMOVAL
INSTALLATION
Hydraulic Drive, Hydraulic Lines—CP18G and CP24G
Hydraulic Drive, Hydraulic Lines—CP30G
Hydraulic Drive, Hydraulic Lines—CP40G
Frame Components Remove and Install—CP18G and CP24G
MACHINE PREPARATION
REMOVAL
INSTALLATION
Frame Components Remove and Install—CP30G
MACHINE PREPARATION
REMOVAL
INSTALLATION
Frame Components Remove and Install—CP40G
MACHINE PREPARATION
REMOVAL
INSTALLATION
Hydraulic Cylinders Disassemble and Assemble
Diagnostics-CP18G, CP24G, CP30G, and CP40G
Electrical Harness Component Location
Electrical Component Location
Electrical Wiring Diagram
Electrical Harness Schematic
Electrical Component Specifications
Hydraulic System Schematic
System Relief Valve Test
Cylinder Relief Valve Test
Hydraulic Motor Case Drain Test
Cold Planer—CP18G, CP24G, CP30G, and CP40G
