-
Model List:
- 3320 Compact Utility Tractor
- 3520 Compact Utility Tractor
- 3720 Compact Utility Tractor
- 1. Introduction
- 1.1. Thank You for Purchasing a John Deere Product
- 1.2. Using Your Operators Manual
- 1.3. Machine Use
- 1.4. Special Messages
- 2. Product Identification
- 2.1. Record Identification Numbers
- 3. Table of Contents
- 4. Safety Labels
- 4.1. Pictorial Safety Signs
- 4.2. DANGER POISON
- 4.3. WARNING KEEP RIDERS OFF
- 4.4. WARNING KEEP RIDERS OFF
- 4.5. WARNING AVOID CRUSHING
- 4.6. WARNING AVOID CRUSHING
- 4.7. WARNING
- 4.8. CAUTION HOT SURFACE
- 4.9. CAUTION READ OPERATORS MANUAL
- 4.10. CAUTION AVOID CRUSHING
- 4.11. Rollover Protection Certification Plate
- 4.12. Drawbar EEC Label
- 4.13. Wagon Hitch EEC Information
- 4.14. Training
- 4.15. Preparation
- 4.16. Operation
- 4.17. Maintenance and Storage
- 4.18. Parking Safely
- 4.19. Avoid Tipping
- 4.20. Keep Riders Off
- 4.21. Towing Loads Safely
- 4.22. Stay Clear of Rotating Drivelines
- 4.23. Checking Wheel Hardware
- 4.24. Wear Appropriate Clothing
- 4.25. Practice Safe Maintenance
- 4.26. Avoid High Pressure Fluids
- 4.27. Prevent Fires
- 4.28. Tire Safety
- 4.29. Handling Fuel Safely
- 4.30. Handling Waste Product and Chemicals
- 5. Operating Controls
- 5.1. Operator Station Controls (PowrReverser)
- 5.2. Operator Station Controls (eHydro No Cab)
- 5.3. Operator Station Controls (eHydro With Cab)
- 5.4. Floor Panel Controls
- 5.5. Air Temperature Controls
- 6. Operating
- 6.1. Daily Operating Checklist
- 6.2. Avoid Damage to Plastic and Painted Surfaces
- 6.3. Entering and Exiting Machine
- 6.4. Adjusting Seat (No Cab)
- 6.5. Adjusting Seat (Tractor With Cab)
- 6.6. Using Rear Window
- 6.7. Using Temperature Controls
- 6.8. Adjusting Blower Speed
- 6.9. Adjusting Tilt Steering Wheel
- 6.10. Using Light Switch
- 6.11. Using Dome Light
- 6.12. Using Key Switch
- 6.13. Using the Instrument Panel
- 6.14. Using Turn Signal Switch
- 6.15. Using Windshield Wiper and Washer
- 6.16. Using Display Mode Switch
- 6.17. Testing Safety Systems
- 6.18. Testing Neutral Start Switch (PowrReverser)
- 6.19. Testing Seat Switch (PowrReverser)
- 6.20. Testing Rear PTO Knob
- 6.21. Testing Rear PTO and Seat Switch Interface
- 6.22. Testing MidPTO and Seat Switch Interface
- 6.23. Testing Rear PTO and Park Brake Interface
- 6.24. Using Fuel ShutOff Valve
- 6.25. Using Brake Pedals (PowrReverser)
- 6.26. Using Brake Pedals (eHydro)
- 6.27. Using Park Brake
- 6.28. Using Throttle Controls
- 6.29. Starting the Engine
- 6.30. Idling the Engine
- 6.31. Starting a Stalled Engine
- 6.32. Stopping the Machine
- 6.33. Operating PowrReverser Transmission
- 6.34. Driving Machine (PowrReverser)
- 6.35. Operating eHydro Transmission
- 6.36. Driving Machine (eHydro)
- 6.37. Using Cruise Control (eHydro With Standard Cruise Control)
- 6.38. Using Cruise Control (eHydro With Automotive Cruise Control Option)
- 6.39. Using SpeedMatch Option (eHydro)
- 6.40. Using MotionMatch (eHydro)
- 6.41. Using LoadMatch (eHydro Model)
- 6.42. Using Differential Lock
- 6.43. Using Mechanical Front Wheel Drive (MFWD)
- 6.44. Using the PowerTakeOff (PTO) Safely
- 6.45. Using Rear and MidPTO (Operator on Seat)
- 6.46. Using Rear PTO (Operator off Seat)
- 6.47. Using Drawbar Hitch
- 6.48. Using 3 Point Hitch
- 6.49. Using iMatch
- 6.50. Connecting Implement Hydraulic Hoses
- 6.51. Using Dual Selective Control Valve Lever
- 6.52. Using Dual Selective Control Valve (SCV) Lock Lever
- 6.53. Using Hydraulic Third Selective Control Valve (SCV)
- 6.54. Using Diverter Valve
- 6.55. Using Accessory Electrical Outlet
- 6.56. Ballasting Machine
- 6.57. Using Front Tow Hitch
- 6.58. Transporting Machine on Trailer
- 6.59. Transporting Machine
- 6.60. Towing Loads
- 6.61. Using Safety Chain
- 6.62. Raising and Lowering RollOver Protective Structure (ROPS)
- 6.63. Using SevenTerminal Outlet
- 7. Replacement Parts
- 7.1. Service Literature
- 7.2. Part Numbers
- 8. Service Intervals
- 8.1. Servicing Your Machine
- 8.2. As Needed
- 8.3. After First 10 Hours
- 8.4. Every 10 Hours or Daily
- 8.5. Every 50 Hours
- 8.6. Every 200 Hours
- 8.7. Every 400 Hours
- 8.8. Every 600 Hours
- 8.9. Every 1200 Hours
- 8.10. Every Two Years or 2000 Hours
- 9. Service Lubrication
- 9.1. Lubricating Machine Grease Fittings
- 9.2. Lubricating 3 Point Hitch
- 10. Service Engine
- 10.1. Avoid Fumes
- 10.2. Engine Oil
- 10.3. Checking Engine Speeds
- 10.4. Checking Engine Oil Level
- 10.5. Changing Engine Oil and Filter
- 10.6. Cleaning Rubber Dust Unloading Valve
- 10.7. Servicing Air Filter Element
- 10.8. Checking Air Filter Hose
- 10.9. Checking Air Restriction Indicator Light
- 10.10. Service Cooling System Safely
- 10.11. Checking Coolant Level
- 10.12. Recommended Engine Coolant
- 10.13. Servicing Cooling System
- 10.14. Checking Radiator Hoses
- 10.15. Adjusting Compressor Belt Tension
- 10.16. Servicing the Alternator Belt
- 10.17. Servicing Water Separator Sediment Bowl
- 10.18. Cleaning Fuel Filter Sediment Bowl and Replacing Filter
- 10.19. Replacing Fuel Filter
- 10.20. Fuel Injection Pump
- 10.21. Fuel Injection Nozzles
- 10.22. Cleaning Grille and Side Screens
- 10.23. Cleaning Radiator Screen and Fins
- 11. Service Transmission
- 11.1. Transmission and Hydraulic Oil
- 11.2. Checking Front Axle Oil Level
- 11.3. Changing Front Axle Oil
- 11.4. Adjusting Front Axle Thrust Bolt Torque
- 11.5. Checking Transmission Oil Level
- 11.6. Changing Transmission Oil and Hydraulic Suction Oil Filter
- 12. Service Steering Brakes
- 12.1. Tractor Without Cab
- 12.2. Tractor With Cab
- 13. Service Electrical
- 13.1. Service the Battery Safely
- 13.2. Checking Battery Electrolyte Level
- 13.3. Removing and Installing Battery
- 13.4. Cleaning Battery and Terminals
- 13.5. Using Booster Battery
- 13.6. Replacing Headlight Bulb
- 13.7. Replacing Light Bulbs (Tractor With Cab)
- 13.8. Replacing Light Bulbs (Tractor Without Cab)
- 13.9. Replacing Fuses
- 14. Service Miscellaneous
- 14.1. Using Proper Fuel (Diesel)
- 14.2. Filling Fuel Tank
- 14.3. Raising and Lowering Hood
- 14.4. Servicing Air Conditioner
- 14.5. Cleaning Cab Air Filter
- 14.6. Checking Cab Rollover Protection System Installation
- 14.7. Checking Wheel Bolts and Hardware
- 14.8. Removing and Installing Wheels
- 14.9. Checking Tire Pressure
- 14.10. Selecting Front Tire Rolling Direction
- 14.11. Changing Wheel Spacing and Tread Width
- 14.12. Changing Wheel Spacing and Tread Width
- 14.13. Cleaning Plastic Surfaces
- 14.14. Cleaning and Repairing Metal Surfaces
- 15. Troubleshooting
- 15.1. Using Troubleshooting Chart
- 15.2. Electrical System
- 15.3. Heater and Air Conditioning System
- 15.4. Machine
- 15.5. Steering
- 15.6. Error Codes
- 16. Storage
- 16.1. Storing Safety
- 16.2. Preparing Machine for Storage
- 16.3. Preparing Fuel and Engine For Storage
- 16.4. Removing Machine From Storage
- 17. Assembly
- 17.1. Delivery Instructions
- 17.2. Check Tire Pressure
- 17.3. Check Fluid Levels
- 17.4. Checking Machine Safety System
- 17.5. Check All Lights
- 17.6. Check Wheel Bolt Torque
- 17.7. Check Machine for Proper Ballast
- 18. Specifications
- 18.1. Electrical System
- 18.2. Fuel System
- 18.3. Drive Train
- 18.4. Hydraulic System
- 18.5. Point Hitch
- 18.6. Drawbar Load
- 18.7. Fluid Capacities
- 18.8. Ground Speeds (Forward and Reverse 2600 Engine RPM)
- 18.9. Front Tires
- 18.10. Front Tire Inflation Pressures
- 18.11. Rear Tires
- 18.12. Rear Tire Inflation Pressures
- 18.13. Tire Loads
- 18.14. Dimensions
- 18.15. Recommended Lubricants
- 18.16. Torque Values
- 19. Declaration of Conformity
- 19.1. , 3520 and 3720 Compact Utility Tractors
- 20. Service Statement
- 20.1. John Deere Parts
- 20.2. The Right Tools
- 20.3. WellTrained Technicians
- 20.4. Prompt Service
- 21. Service Record
- 21.1. Record Service Dates






