John Deere HD200 CE ProGator GPS PrecisionSprayer Operator Manual OMUC27311
$30
- Type Of Manual: Operator Manual
- Manual ID: OMUC27311
- Format: PDF
- Size: 5.6MB
- Number of Pages: 80
Description
-
Model List:
- HD200 CE ProGator GPS PrecisionSprayer
- 1. Introduction
- 1.1. Thank You for Purchasing a John Deere Product
- 1.2. Using Your Operators Manual
- 1.3. Professional Use Only
- 1.4. Machine Use
- 1.5. Special Messages
- 1.6. Service Literature
- 2. Contents
- 3. Product Identification
- 3.1. Product Compatibility
- 3.2. Record Identification Numbers
- 4. Safety Labels with Text
- 4.1. Safety Label Location
- 4.2. Understanding the Machine Safety Labels
- 4.3. WARNING
- 4.4. WARNING
- 4.5. CAUTION
- 4.6. WARNING
- 4.7. CAUTION
- 4.8. WARNING
- 5. Safety Labels without Text
- 5.1. Safety Label LocationSprayer Tank
- 5.2. Safety Label LocationSpray Booms (5.5 m (18 ft.)
- 5.3. Understanding the Machine Safety Labels without Text
- 5.4. Avoid Injury From Drinking Water
- 5.5. Avoid Injury From Chemical Hazards
- 5.6. Do Not Enter Tank
- 5.7. Read Operators Manual
- 5.8. Avoid Injury From Crushing
- 5.9. Avoid Injury From Moving Parts
- 5.10. Read Operators Manual, Avoid Moving Parts, Keep Bystanders Away
- 5.11. Avoid Injury From Moving Boom
- 5.12. Avoid Injury From Boom Swing Area
- 5.13. Read Safety in Machine Operators Manual
- 5.14. Operate Sprayer Safely
- 5.15. Parking Safely
- 5.16. Mix and Handle Chemicals Safely
- 5.17. Read Chemical Container Label
- 5.18. Handle Chemical Products Safely
- 5.19. Practice Safe Maintenance
- 5.20. Wear Appropriate Clothing
- 5.21. Avoid High Pressure Fluids
- 5.22. Dispose of Chemicals Properly
- 5.23. Handling Waste Product and Chemicals
- 6. Preparing Vehicle
- 6.1. Preparing the Machine
- 6.2. Install Display and Switchbox
- 6.3. Install Receiver
- 6.4. Install Throttle Kit
- 6.5. Install Boom
- 6.6. Install Radio (Option)
- 6.7. Install Rinse Kit (If Included)
- 6.8. Install Pump Kit (If Included)
- 6.9. Install Side Mirror
- 6.10. Install Clothing Locker
- 6.11. Install Labels
- 6.12. Software Updates
- 6.13. Component Activations
- 6.14. ProGator System Configuration
- 6.15. Operational Check
- 6.16. John Deere Operations Center
- 7. Component Overview
- 7.1. Gen4 Display
- 7.2. Starfire Receiver
- 7.3. GreenStar Rate Controller
- 7.4. ATU300 Steering Control Unit
- 7.5. Switchbox Controller
- 7.6. Modular Telematics Gateway (Dealer Installed Attachment)
- 7.7. Mobile RTK Modem 4G LTE (Dealer Installed Attachment)
- 7.8. Solution Tank
- 7.9. Manifold (Valve Stack)
- 8. Operating
- 8.1. Operating the Sprayer
- 8.2. GreenStar System Introduction
- 8.3. Display Help Files and Additional Settings
- 8.4. Entering Activations into the Display
- 8.5. Configuring the StarFire 6000 Receiver
- 8.6. Configuring the GreenStar Rate Controller
- 8.7. Configuring the AutoTrac Universal 300
- 8.8. Configuring the Gen 4 Display Equipment Manager
- 8.9. Configuring the Gen 4 Display Fields Boundaries
- 8.10. Configuring the Gen 4 Display Work Setup
- 8.11. Configuring the Gen 4 Display Section Control
- 8.12. Configuring the Gen 4 Display Layout Manager
- 8.13. Configuring Radio Based RTK (Base Station) GPS Corrections
- 8.14. Configuring MobileRTK GPS Corrections
- 8.15. Spray Tip Operation
- 8.16. Spray Tip Selection
- 8.17. Flood Style Spray Tip
- 8.18. Ultra LowDrift Style Spray Tip
- 8.19. Flat Fan Style Spray Tip
- 8.20. Adjusting Application Rate
- 8.21. Using the Personal Wash Tank
- 8.22. Filling and Draining Sprayer Tank
- 8.23. Using ThreeWay Valve
- 8.24. Using the Agitator
- 8.25. Using Boom Wings
- 8.26. Setting System Relief Pressure (Diaphragm Pump Only)
- 8.27. Adjust Boom Height
- 8.28. Adjust Boom Wing Level
- 8.29. Raising and Lowering Sprayer
- 8.30. Transporting
- 9. Removing and Storing
- 9.1. Prepare Machine for Removal
- 9.2. Disconnect Hydraulic Hoses
- 9.3. Disconnect Rear Wiring Harness
- 9.4. Removing Sprayer Without Support Stands
- 9.5. Removing Sprayer With Optional Support Stands
- 9.6. Storing Safety
- 9.7. Winterization and Storage
- 9.8. Removing From Storage
- 10. Installing
- 10.1. Installing Sprayer on Machine Without Optional Support Stands
- 10.2. Installing Sprayer on Machine With Optional Support Stands
- 11. Optional Attachments and Kits
- 11.1. Using Eductor
- 11.2. Using Foam Marker
- 11.3. Using Manual and Electric Hose Reels
- 11.4. Using Rinse Tank
- 12. Service
- 12.1. Service Intervals Standard Equipment
- 12.2. Service Intervals Optional Equipment
- 12.3. Cleaning the Sprayer
- 12.4. Servicing the Inline Strainer
- 12.5. Verifying Sprayer Output
- 12.6. Checking Main Circuit Breaker
- 12.7. Checking Fuses and Boom Wing Actuator Circuit Breaker
- 12.8. Adjusting Boom Wing Spring Tension
- 12.9. Lubricating Boom Wing Pivots
- 12.10. Inspecting and Cleaning Vented Fill Covers
- 12.11. Servicing Foam Marker Kit
- 12.12. Lubricating Ground Wheels
- 12.13. Lubricating Jack Stands
- 12.14. Servicing Hose Reel
- 12.15. Servicing the Diaphragm Pump
- 12.16. ProStopE Assembly Process
- 12.17. Hydraulic Proportional Control Valve Manual Override Adjustment
- 13. Troubleshooting
- 13.1. Using Troubleshooting Chart
- 13.2. ProGator GPS PrecisionSprayer HD200 CE
- 14. Specifications
- 14.1. Standard Equipment
- 14.2. Optional Equipment
- 14.3. Nozzle Flow Rate
- 14.4. Diaphragm Pump Application Performance Chart
- 15. John Deere Quality Statement
- 15.1. John Deere Quality
- 16. Declaration of Conformity
- 16.1. EC Declaration of Conformity
Related products
-50%
Original price was: $20.$10Current price is: $10.
-50%
Original price was: $20.$10Current price is: $10.
-50%
Original price was: $20.$10Current price is: $10.
-50%
Original price was: $20.$10Current price is: $10.
-50%
Original price was: $20.$10Current price is: $10.
