Table of Content:
1 Introduction
1.1 Thank You for Purchasing a John Deere Product
1.2 Using Your Operator’s Manual
1.3 Machine Use
1.4 Special Messages
1.5 Service Literature
1.6 Parts
2 Contents
3 Product Identification
3.1 Product Compatibility
3.2 Record Identification Numbers
3.3 Sprayer Sub Components
4 Safety Labels No-Text
4.1 Safety Label Location—Sprayer Tank
4.2 Safety Label Location—Spray Booms (5.5 m (18 ft.)
4.3 Safety Label Location—Spray Booms (4.6—6.4 m (15—21 ft.)
4.4 Understanding the Machine Safety Labels without Text
4.5 Avoid Injury From Drinking Water
4.6 Avoid Injury From Chemical Hazards
4.7 Read Operators Manual
4.8 Avoid Injury From Crushing
4.9 Read Operators Manual, Avoid Moving Parts, Keep Bystanders Away
4.10 Avoid Injury From Moving Boom
4.11 Avoid Injury From Boom Swing Area
5 Safety
5.1 Read Safety in Machine Operator’s Manual
5.2 Operate Sprayer Safely
5.3 Parking Safely
5.4 Mix and Handle Chemicals Safely
5.5 Read Chemical Container Label
5.6 Handle Chemical Products Safely
5.7 Practice Safe Maintenance
5.8 Wear Appropriate Clothing
5.9 Avoid High Pressure Fluids
5.10 Dispose of Chemicals Properly
5.11 Handling Waste Product and Chemicals
6 Preparing Vehicle
6.1 Preparing the Machine
6.2 Controller Mount Bracket Kit Components
6.3 Tank Components
6.4 Electrical Components
6.5 Pump and Hydraulic Components*
6.6 Personal Wash Tank Components
6.7 Install Control Box
6.8 Install Cylinder Support Bracket (HD300)
6.9 Install Sprayer
6.10 Install Power Harness
6.11 Install Console Wire Harness
6.12 Install Sprayer Tank Components
6.13 Connect Sprayer Main Harness to Control Box
6.14 Connect Rear Wiring Harness
6.15 Install Frame Clamps
7 Component Overview
7.1 Solution Tank
7.2 Manifold (Valve Stack)
7.3 Pump
8 Operating Controls
8.1 Digital Manual Control Box
9 Operating
9.1 Spray Tip Operation
9.2 Spray Tip Selection
9.3 Flood Style Spray Tip
9.4 Ultra Low-Drift Style Spray Tip
9.5 Flat Fan Style Spray Tip
9.6 Using Digital Manual Control Box
9.7 Operating the Sprayer
9.8 Using the Personal Wash Tank
9.9 Filling and Draining Sprayer Tank
9.10 Using Three-Way Valve
9.11 Using the Agitator
9.12 Adjusting Throttling Valves
9.13 Using Boom Wings
9.14 Using Boom Wing Extensions (4.6/6.4 m (15/21 ft) Boom Only)
9.15 Adjust Boom Height
9.16 Adjust Boom Wing Level
9.17 Raising and Lowering Sprayer
9.18 Transporting
10 Removing and Storing
10.1 Prepare Machine for Removal
10.2 Disconnect Hydraulic Hoses
10.3 Disconnect Rear Wiring Harness
10.4 Removing Sprayer Without Support Stands
10.5 Removing Sprayer With Optional Support Stands
10.6 Storing Safety
10.7 Winterization and Storage
10.8 Removing From Storage
10.9 Remove and Store Control Box
11 Installing
11.1 Installing Sprayer on Machine Without Optional Support Stands
11.2 Installing Sprayer on Machine With Optional Support Stands
12 Optional Attachments and Kits
12.1 Using Eductor
12.2 Using Foam Marker
12.3 Using Manual and Electric Hose Reels
12.4 Using Rinse Tank
13 Service
13.1 Service Intervals – Standard Equipment
13.2 Service Intervals – Optional Equipment
13.3 Parts
13.4 Grease
13.5 Cleaning the Sprayer
13.6 Servicing the Inline Strainer
13.7 Verifying Sprayer Output
13.8 Checking Main Circuit Breaker
13.9 Checking Fuses and Boom Wing Actuator Circuit Breaker
13.10 Adjusting Boom Wing Spring Tension
13.11 Lubricating Boom Wing Pivots
13.12 Inspecting and Cleaning Vented Fill Covers
13.13 Servicing Foam Marker Kit
13.14 Lubricating Ground Wheels
13.15 Lubricating Jack Stands
13.16 Servicing Hose Reel
13.17 Installing a Test Flow Meter
13.18 Installing a Test Pressure Gauge
14 Troubleshooting
14.1 Using Troubleshooting Chart
14.2 SelectSpray HD200 | HD300
15 Specifications
15.1 HD200
15.2 HD300
15.3 Boom 5.5 m (18 ft.) Spray Width
15.4 Extendable Boom 4.6 / 6.4 m (15 / 21 ft.) Spray Width
15.5 Centrifugal Pump
15.6 Personal Wash Tank
15.7 Optional Equipment
15.8 Nozzle Flow Rate
15.9 Centrifugal Pump Performance Chart
16 John Deere Quality Statement
16.1 John Deere Quality