Case Farmall 110A, 120A, 130A, 140A Tier 4B (Final) Tractor Operator Manual 51490496 PDF
$20
- Type Of Manual: Operator Manual
- Manual ID: 51490496
- Format: PDF
- Size: 36.1MB
- Number of Pages: 356
Description
-
Model List:
- Farmall 110A Tier 4B (Final) Tractor
- Farmall 120A Tier 4B (Final) Tractor
- Farmall 130A Tier 4B (Final) Tractor
- Farmall 140A Tier 4B (Final) Tractor
- 1. GENERAL INFORMATION
- 1.1. Note to the owner
- 1.2. Intended use
- 1.3. ElectroMagnetic Compatibility (EMC)
- 1.4. Product identification
- 1.5. Product Identification Number (PIN)
- 1.6. Operators manual storage on the machine
- 1.7. Machine orientation
- 1.8. Machine components
- 1.9. Selective Catalytic Reduction (SCR) exhaust treatment Product overview
- 2. SAFETY INFORMATION
- 2.1. Safety rules and signal word definitions
- 2.2. Safety rules
- 2.3. Ecology and the environment
- 2.4. Safety signs
- 2.5. Informational decals
- 3. CONTROLS AND INSTRUMENTS
- 3.1. Access to operators platform
- 3.1.1. Proper entry and exit
- 3.2. Operators seat
- 3.2.1. Mechanical operators seat
- 3.2.2. Pneumatic operators seat
- 3.2.3. Seat belt operation
- 3.3. Instructional seat
- 3.3.1. Overview
- 3.4. Forward controls
- 3.4.1. Front console
- 3.4.2. Foot pedals
- 3.4.3. Selective Catalytic Reduction (SCR) exhaust treatment Overview
- 3.5. Lefthand side controls
- 3.5.1. Power TakeOff (PTO) (without cab)
- 3.5.2. Parking brake
- 3.5.3. Door and window operation
- 3.5.4. Storage
- 3.6. Righthand side controls
- 3.6.1. Transmission controls
- 3.6.2. Hi / Lo Transmission
- 3.6.3. Power TakeOff (PTO) (with cab)
- 3.6.4. Hydraulic controls
- 3.6.5. Righthand post
- 3.6.6. Heating, Ventilation, and Air Conditioning (HVAC) controls
- 3.6.7. Door and window operation
- 3.7. Rearward controls
- 3.7.1. Rear window operation
- 3.7.2. Rear window wiper
- 3.8. Overhead controls
- 3.8.1. Radio
- 3.8.2. Radio operation
- 3.8.3. Dome light
- 3.8.4. Roof hatch
- 3.9. Display
- 3.9.1. Setup menu
- 3.9.2. Backlighting and dimming
- 3.9.3. Analog/Digital Instrument Cluster (ADIC)
- 3.9.4. Warning and status indicators
- 3.9.5. Display overview
- 3.9.6. Alarms
- 3.9.7. Overview
- 3.9.8. Maintenance intervals
- 3.9.9. Audible alarm buzzer
- 3.9.10. Fuel consumption units
- 3.9.11. Active error codes and warnings
- 3.9.12. Lamps and gauges
- 3.9.13. Display
- 4. OPERATING INSTRUCTIONS
- 4.1. Commissioning the unit
- 4.1.1. Runin period of a new machine
- 4.1.2. Roll Over Protective Structure (ROPS)
- 4.2. Starting the unit
- 4.2.1. Starting the engine
- 4.2.2. Engine starting aids
- 4.3. Stopping the unit
- 4.3.1. Stopping the tractor
- 4.3.2. Hydraulic trailer brakes
- 4.4. Moving the unit
- 4.4.1. General transmission operation
- 4.4.2. Steering control
- 5. TRANSPORT OPERATIONS
- 5.1. Road transport
- 5.1.1. Basic instructions
- 5.1.2. High visibility position markers
- 5.2. Recovery transport
- 5.2.1. Towing the tractor
- 6. WORKING OPERATIONS
- 6.1. Tires and wheels
- 6.1.1. Tire load and inflation charts
- 6.1.2. Tractor ballasting
- 6.1.3. Liquid ballast
- 6.1.4. Front wheel tread settings
- 6.1.5. Rear wheel tread settings
- 6.1.6. Bar axle adjustment
- 6.1.7. Dual rear wheels
- 6.2. Driveline
- 6.2.1. Creeper gears
- 6.2.2. FourWheel Drive (4WD)
- 6.2.3. Differential lock
- 6.2.4. Front axle oscillation
- 6.3. Hydraulic system
- 6.3.1. Bosch remote valves
- 6.3.2. Sohipren remote valves
- 6.3.3. Hydraulic Power Lift (HPL)
- 6.3.4. Hydraulic remote control valves
- 6.3.5. Connecting remote cylinders
- 6.3.6. Bleeding remote cylinders
- 6.3.7. Operating singleacting hydraulic cylinders
- 6.3.8. Operating doubleacting hydraulic cylinders
- 6.3.9. Operating continuous flow hydraulic equipment
- 6.3.10. Hydraulic remote control valves
- 6.3.11. Connecting remote cylinders
- 6.3.12. Operating singleacting hydraulic cylinders
- 6.3.13. Operating doubleacting hydraulic cylinders
- 6.4. Implements
- 6.4.1. Adjusting the drawbar
- 6.4.2. Hitch operation
- 6.4.3. Power TakeOff (PTO) operation
- 7. MAINTENANCE
- 7.1. General information
- 7.1.1. Safety rules Machine service access
- 7.1.2. Warranty notice
- 7.1.3. Jacking points
- 7.1.4. Opening the hood
- 7.1.5. Fueling the machine
- 7.1.6. Selective Catalytic Reduction (SCR) exhaust treatment Basic instructions
- 7.1.7. General specification Biodiesel fuels
- 7.1.8. General specification Diesel fuel
- 7.1.9. Torque Minimum tightening torques for normal assembly
- 7.1.10. Standard torque data for hydraulics
- 7.1.11. Organic Acid Technology (OAT) coolant
- 7.1.12. Fluid capacities and lubricants
- 7.1.13. Engine oil Recommended engine oil for operating temperature ranges
- 7.2. Maintenance planning
- 7.2.1. Maintenance chart
- 7.3. Warning light on
- 7.3.1. Engine air filter (outer element) Clean
- 7.3.2. Fuel filter water separator Drain fluid
- 7.3.3. Brake fluid Level make up
- 7.4. Every 10 hours or daily
- 7.4.1. Engine oil Level make up
- 7.4.2. Radiator, oil cooler, and condenser Clean
- 7.4.3. Engine cooling system Level make up
- 7.5. Every 50 hours
- 7.5.1. Tire pressure Check
- 7.5.2. Transmission, rear axle, and hydraulic system oil Level make up
- 7.5.3. Brake fluid Level make up
- 7.5.4. Windshield washer fluid Level make up
- 7.5.5. Fuel filter water separator Drain fluid
- 7.5.6. Cab recirculation air filter Clean
- 7.5.7. Cab air filter Clean
- 7.5.8. Wheel hardware Check
- 7.5.9. Grease points Grease
- 7.5.10. Clutch pedal Adjust
- 7.6. Every 300 hours
- 7.6.1. FourWheel Drive (4WD) front axle differential oil Level make up
- 7.6.2. FourWheel Drive (4WD) front axle hub oil Level make up
- 7.6.3. Transmission and hydraulic oil filter Replace
- 7.6.4. Cab and safety frame mounting hardware torque Check
- 7.6.5. Parking brake Adjust
- 7.6.6. Brake pedal Adjust
- 7.6.7. Alternator drive belt Check
- 7.6.8. Air conditioning compressor belt Check
- 7.6.9. Battery cables Check
- 7.7. Every 600 hours
- 7.7.1. Diesel Exhaust Fluid (DEF)/AdBlue supply module prefilter Clean
- 7.7.2. Engine oil Change fluid
- 7.7.3. Engine air filter (outer element) Replace
- 7.7.4. Fuel filter water separator Replace
- 7.8. Every 1200 hours or annually
- 7.8.1. Diesel Exhaust Fluid (DEF)/AdBlue supply module prefilter Replace
- 7.8.2. Transmission, rear axle, and hydraulic system oil Change fluid
- 7.8.3. FourWheel Drive (4WD) front axle differential oil Change fluid
- 7.8.4. FourWheel Drive (4WD) front axle hub oil Change fluid
- 7.9. Every 3600 hours or two years
- 7.9.1. Diesel Exhaust Fluid (DEF)/AdBlue supply module main filter Replace
- 7.10. Every 4000 hours or four years
- 7.10.1. Engine coolant Change fluid
- 7.11. As required
- 7.11.1. Diesel Exhaust Fluid (DEF)/AdBlue supply module inlet filter Replace
- 7.11.2. Diesel Exhaust Fluid (DEF)/AdBlue tank inlet filter Replace
- 7.11.3. Diesel Exhaust Fluid (DEF)/AdBlue supply module backflow filter Replace
- 7.11.4. Headlights Adjust
- 7.11.5. Headlight bulb Replace
- 7.11.6. Work light bulb Replace
- 7.11.7. Rear light bulb Replace
- 7.11.8. Steering stops Adjust
- 7.11.9. Steering toein Adjust
- 7.11.10. Roof hatch Cleaning
- 7.11.11. Parking brake Adjust
- 7.12. Fuse and relay locations
- 7.12.1. Chassis fuse box
- 7.12.2. Engine fuse box
- 7.12.3. Other fuses and relays
- 7.13. Storage
- 7.13.1. Preparing for storage
- 7.13.2. Removing from storage
- 8. TROUBLESHOOTING
- 8.1. Symptom(s)
- 8.1.1. Engine
- 8.1.2. Transmission
- 8.1.3. Electrical system
- 8.1.4. Hydraulic system
- 8.1.5. Hydraulic remote control valves
- 8.1.6. Threepoint hitch
- 8.1.7. Brakes
- 9. SPECIFICATIONS
- 9.1. Length and height
- 9.2. Width
- 9.3. Ground clearance
- 9.4. Maximum side slope operation
- 9.5. Power TakeOff (PTO)
- 9.6. Hydraulic system
- 9.7. Threepoint linkage
- 9.8. Brake system
- 9.9. Steering system
- 9.10. Electrical system
- 9.11. Lubrication system Capacities
- 10. ACCESSORIES
- 10.1. Engine
- 10.2. Chassis
- 10.4. Roll Over Protective Structure (ROPS)
- 10.5. Safety
- 10.6. Hydraulics
- 10.7. Hitch
- 11. FORMS AND DECLARATIONS
- 11.1. Delivery report Owner copy
- 11.2. Delivery report Dealer copy
